Leaderboard

I ordered the ram air chamber ,i dont know if it is fiberglass or plastic ,i may have to make a mold from the factory type chamber so i can make a fiberglass one so i can modify it. View from what could be the cock pit

Tried out a two part self leveling Epoxy seam sealer, worked fantastic. Dries in fifteen minutes

Last coat of primer sprayed and it is slick ,a good wet sanding and the top is done ,it will set a couple of days first .

First block sanding with 180 grit . Nice and flat except for what looks like two thumb prints at each rear corner . It will get primed one more time and then blocked wet starting with 400 then 600 then 1000 ,that should take out the two marks at the rear ,if it doesnt i will leave them because i will still have to block sand the mold and they will then be a high spot and easily sand out and them buff. ,still have one scoop to block but my fingers are raw and burn like fire

better figure out how much you want to charge. Im gonna want one! I hope you were listening to Disturbed or Metallica when it popped.