Leaderboard

Making great progress on the custom rear bumper project for the Boss! Slow going but it's turning out just the way we wanted. Always a plus! http://1970boss302.blogspot.com/2018/04/rear-bumper-fabrication-project-part-2.html

Close to 80 here today ,not a cloud in the sky .I put up a new fence and double gate ,and mowed the pasture

That's ACC hot. What you want for an electric choke is a RUN-only wire. In the engine compartment, the best source is the green/red wire at the voltage regulator plug. For 1970's only, there's a large white female bullet with a greyish-blue wire for the carb solenoid anti-backfire solenoid; that wire is also RUN-only.

That pinion support looks huge against the red primer

This thread is still here ?? I took the third member apart.it has 5.14s and a mini spool 31 spline .i will not be using those gears ,that motor would be turning 7 grand on the free way. I cleaned the aluminum pinnion support ,looks like new .It has billet steel caps ,like to never found a socket to fit in to remove the bolts.I glass beaded the N case ,it is spotless ,i blew it out well and washed it out with acetone. Masked it off an sprayed it with dtm epoxy ,this is like a plastic coating when cured ,i will let it cure for ...ah who am i kidding ,it will probably set a couple of months before i get back to it :( I still have to order the Detroit locker and a set of 3.50 gears

For all you users out on the West Coast or in the south, here's what April sometimes looks like in the north.... Blizzard time.

I went to the Fresno swap meet this morning ,if you were looking for any type of Ford part this was not the place to be . In fact ,wasnt much of any parts other than junk . I did how ever get a good laugh ,if you look close you will laugh also ,so it wasnt a totaly waisted day