Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 09/20/2017 in all areas

  1. 3 points
    Raven R code

    Aquarius is on the way!

    I believe someone with balls once said "a mans gotta do what a mans gotta do" . Might have been Clint Eastwood or John Wayne.....but not sure if they told that to their wife with mustang parts all over the dining room though.
  2. 1 point
    Vicfreg

    1970 Convertible Restoration

    Oh, one item that is also very neat is the relay pack that you see in the bottom picture. It allows you to run halogen headlights, and fog lights. The kit also supports the 1969 dual headlight setup. You can see my writing.... LB - Low Beam, HB - High Beam, FG - Fog (driving lights), HN - Horn, IG - Ignition. The ignition relay is only used on 1970s. It is there to allow the use of the column mounted ignition switch that was used in 1970, versus the 1969 dash mounted switch. There is a nice pre-assembled jumper wire kit that comes with the AAW package that plugs into the 1970 factory connector.
  3. 1 point
    MAC390

    Fastback rear windscreen rubber

    Mine was a Daniel Carpenter, my trim went down ok, use plenty of sealer.
  4. 1 point
    JD08

    What did you do to/for your Mustang today?

    I said I was sorry. Let it go already.
  5. 1 point
    Midlife

    ~ 1969 mystery hardware

    Those bolts are impossibly from GM. They are not completely rusted through...
  6. 1 point
    Ridge Runner

    Fastback rear windscreen rubber

    I believe the small strip is to seal water out from between the rubber gasket and the trim ,my original gasket has the strip and it is hiden under the stainless trim
  7. 1 point
    This might help..... http://fixingthetruckagain.blogspot.com/2016/12/rebuilding-1969-mustang-non-tilt.html?m=1
  8. 1 point
    RPM

    A REAL Schematic

    Heck, it'll make me feel better after reading all that!
  9. 1 point
    Ridge Runner

    ~ 1969 mystery hardware

    Not really ,you would be surprised at some of the things i have seen on these cars . Someone just found some GM bolts and used them because it was easier than finding the correct bolts
  10. 1 point
    Midlife

    A REAL Schematic

    Bigmal: have an adult beverage on us! That'll make you feel a whole lot better!
  11. 1 point
    RPM

    Mach 1 resto in Australia

    Great stuff Mac! You going to the Gosford Museum made me look into the origin of Gosford. I live around the corner from a railroad stop and road named Gosford in Bakersfield California. My Gosford was founded by the Southern Pacific Railroad in 1893 and named in honor of the Earl of Gosford, former landowner. Gosford was unincorporated community in Kern County, California.[1] It is located on the Southern Pacific Railroad 7 miles (11 km) southwest of Bakersfield Your Gosford was named in 1839 after Archibald Acheson, 2nd Earl of Gosford – a friend of the then Governor of New South Wales George Gipps. So now you know the rest of the story Mac. Where's Paul Harvey when you need him? :)
  12. 1 point
    Raven R code

    Aquarius is on the way!

    Getting the rear end buttoned up.....
  13. 1 point
    JoeyS

    First Engine Rebuild

    Here is a link to the pdf "how to rebuild your SMALL-BLOCK FORD"


×
×
  • Create New...